Pactor II Pro
HF/SSB Premiere Radio Modem
- New, more powerful 24 bit DSP running at 100 MHz with a computing power of 100 MIPS (max.)
- 2 MB static RAM.
- New high quality rugged case.
- Built-in audio amplifier. Simply connect your favorite speaker and use the PTC-IIpro as audio de-nosier. The volume is controlled by software!
- Highly stable temperature-compensated oscillator. Makes your PACTOR-II/III connection even more stable!
- New transceiver control port supports transceiver with TTL and V24 interface out of the box!
- Silicon serial number. To easily identify your unit in case of theft!
- Reduced power consumption! Only 200 mA at 13.8 Volt.
- Software controlled power off function. The new OFF command turns the unit off. Any character sent to the PTC-IIpro over the serial interface will switch it on again.
|
|
Purchase Pactor II Pro now from our catalog...
Comes with Pactor II installed standard
|
|
<< Back to Pactor Index
Comes with: Power Connector, USB cable, Audio cable, Control cable, CD-ROM, Installation Guide
SPECIAL CABLES AVAILABLE - GMN can help solve your cable puzzles. Contact us for more information on custom cables and connectors.
Cables ~ The Short Story
|
|
Standard features:
- PACTOR-III, PACTOR-II, PACTOR-I, AMTOR, NAVTEX, RTTY
- PSK31 With spectroscope display on the tuning display.
- SSTV All different kinds of SSTV. Useable with nearly all available SSTV software.
- FAX Including AM-FAX for Meteosat.
- Audio de-noiser/filter. The PTC-IIpro is fully usable as DSP-filter for all modes. Features: Auto-peak, auto-notch, passband-filter, inversion, delay-line, function-generator.
- CW-Terminal CW-operation (RX and TX) with automatic speed adaptation using high performance DSP-algorithms.
- Three simultaneously available communication ports: HF and up to two VHF/UHF Packet ports.
- Separate transceiver control port for remote operation of Icom, Kenwood, Yaesu, R&S and SGC equipment.
- 32-bit system with Motorola 68360 as CPU, clocked at 25 MHz.
- 24-bit Motorola DSP 56303 clocked at up to 100 MHz (computing power: 100 MIPS)
- Firmware stored in flash memory. Easy update via serial RS232 link to the PC. The update is free of charge and available from many Packet-Radio mailboxes and from this Internet site.
- Mark and space frequencies are freely programmable in 1 Hz steps.
- Audio output-levels for all PSK- and FSK-modes programmable separately.
- Build-in mailbox with comprehensive features and simultaneous access from all modes (PACTOR-I, II, III, AMTOR, PACKET).
- Programmable squelch function for RTTY operation.
- Battery backup for the clock and C-MOS RAM. No mail-loss when switched off.
- Mail display at the front panel shows the operator at once if there is a new mail for him. All significant link and controller stats are displayed at the front panel with 2-color LEDs and on the terminal-screen.
- Excellent tuning display with 15 2-color-LEDs with center-function. The antique X-Y-tube display is not required any more.10-character dot-matrix-display for mode and other parameters as the call sign of a connecting station and much more.
- Channel-busy detection displayed on the PTC-display as well as on the terminal-screen.
- Comprehensive filtering of all in- and outputs for excellent electromagnetic compatibility.
- HF <--> VHF/UHF gateway and crossband digipeating with comprehensive and automated link establishment features from remote.
- Hostmode, extended hostmode, CRC-hostmode. Full compatible to nearly all modern PC programs. Fully intergratable in FBB/Winlink networking and mailing systems.
|
